Contact Us

Use the form on the right to contact us.

You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right. 

Jerikovn. 16
Oslo, 1067

+4722301730

This is the Datamatik SCADA online store. Datamatik acts as a distributor and project integrator for Motorola Radio and SCADA products.

The company specializes in Remote Control Operations, Supervisory Data transfer, Mototrbo Tetra digital telemetry transfer.

Radio configuration

 
 

Using CPS

The CPS software is a propriatory suite from Motorola Solutions to configure your Mototrbo digital radio infrastructure. This tutorial aims at configuring your radio frequencies, your call IDs, your call groups, and finally setting-up the radios to use the USB port located on the backpanel of the radios.

 

Seting-up the radio ID and the group call ID

Open the CPS software and read the configuration from the radio.Set-up the Radio ID as 01 to set-up the radio IP address to 12.0.0.1. Set-up the group Call ID to 10 to set-up the radio submask to 255.0.0.10.

group-call-radio-ID.png

The Radio ID is accessible from the Radio General Settings tab.
The GroupCall ID is accessible from the Contacts/Digital/ tab. The first thing to do is to add a contact setting-up its GroupID. Then add that Group as part of the RX Group Lists. We are now in a position to Define a 'SCADA Channel' which listens+talks to that GroupList (set-up the RX Group List+ Set-up the TX Group List). Finally, add that SCADA Channel into the Scan List. Remember to update the Scan/Roam List to the Channel Tab and tick the AutoScan function.

-Set-up the General/ Settings Microphone  to listen to the Rear Accessories to establish a USB connection.

-Set-up the Accessories Cable Type to Rear Data Accessory.

-Set-up the radio network to forward to PC via Non-IP Peripherial.